It’s designed to be a linear device, which means it’s purpose is to get the signal from point A to point B with as little alteration as possible, all the…
The maximum output voltage is 10v per channel, for impedances above appx. 50 Ohm. Thus power at any give impedance is 100,000 / Resistance, e.g. 100,000 / 600= 166.6mW or…
Given the wide range of headphones/IEM sensitivities (e.g. from 140dB/V – a 30dB difference), we felt that as much attenuation as 24dB was needed for the most sensitive headphones. Using…
So-called ‘audiophile USB cables’ are often of questionable construction and are neither certified to USB standards nor do they conform to the USB specifications relevant. In this case, they often…
The iEmatch is a purely passive device. It cannot by itself produce distortion. Any distortion observed is from the driving amplifier. Further question: But I tested mine with an IEM…
It is due to different variations and height differences. Variations: There are around 48 different DC barrel types, therefore, each one can not be provided so you may need to…
Earth/ground is needed to make shielding against all sorts of noises effective, even if the system doesn’t have noises without an earth/ground present it’s still recommended. For all mains electrical…
Check if there is an earth/ground connection in the audio system as we suspect it is missing. Due to the rules about EMC the iPower contains a so-called Y-capacitor. This…
Incorrect polarity lights up if: The polarity is incorrect. The wiring is balanced (no defined polarity). Earth and Neutral have a significant voltage between them (weak/bad earth). A simple test…
This is because Apple cables have a chip inside to release the digital extraction whilst Android is different, its an actual resistor to short out a signal path. Therefore one…
The SPDIF iPurifier is rated to tolerate normal variations of USB voltage, that is it will work reliably from 4.5V to 5.5V. The absolute maximum beyond which damage may be…
Yes, the SPDIF iPurifier is agnostic as to what audio format is packed within the SPDIF stream, it may be DSD as DoP, DTS, Dolby digital or conventional PCM (or…
Will the AC iPurifier work with the dual phase power supply? Example: Philippines Answer: The AC iPurifier works with any mains system. For best results, the earth/ground needs to be…
Battery products: If the DAC/amplifier and the DAP (digital audio player) both run on battery and there are no other connections, then there is no need for an earth/ground connection.…
Question: I have FH3 IEM with FIIO LC RD 4.4 balanced cable. I also have Meze 99 Classic with Meze 4.4mm silver cable. So I have all my cables connector…
I’m using a local Network based on power-line communication. The slot where I would try the purifier is not equipped with a power-line communication plug but wanted to make sure…
Yes, it will work with the Raspberry Pi 2 or under since the Raspberry Pi 3 requires up to 3A which the iPower can not supply, however, the iPowerX can…
The noise reduction system has two components, one that attenuates differential noise (between live and neutral) and one that attenuates common mode noise (between live/neutral & earth). Differential noise reduction…
The iPurifier 3 will mainly help devices that use the isochronous transfer (audio & video in essence), it may (or may not) help with devices that use bulk transfer (hard-drives…